Walk-in shower
Tub-to-shower
Freestanding tub
Kohler
Moen
Delta
Frameless glassFree in-home design visit - walk-in showers, tub-to-shower conversions, and Kohler, Moen, and Delta fixtures planned to your exact space
Trusted Tub to Shower Conversion in Paradise, NV
If your tub has become a dust collector, or stepping over a 14-inch wall has turned into a gamble, a tub to shower conversion in Paradise solves the problem without forcing a full bathroom gut job. We’re Bathroom Remodeling Paradise, and bathrooms are the only thing we do. That focus matters here: converters who also hang drywall, lay flooring and build additions split their attention; we don’t. Our technicians have up to 15 years of experience, and every project we take on is waterproofed to Schluter standards instead of being tiled over whatever was there before.

Paradise homes built in the 1970s and 1980s often hide the same surprise behind a tub surround: a substrate that’s been quietly failing for years. We plan for that and price it into the written estimate, not into a surprise change order mid-job. Call (888) 349-5908 to schedule your free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
What Our Tub to Shower Conversion Service Includes
Tub to shower conversion isn’t a liner you drop over the old tub. It’s a defined scope of work: demolition, plumbing rough-in, waterproofing, tile or panel finish, glass, and a drain that actually slopes. Here’s what each part of the job involves when we take it on.
Tub Removal and Rough Plumbing
Every conversion starts by cutting the old tub loose and pulling it out through the door frame. That’s when we can see the valve, the supply lines and the drain, and confirm whether the existing rough-in is usable or needs to be repositioned. We check for a shutoff that actually closes, corrosion at the valve, and any soft framing around the tub apron. If the drain sits in a spot that won’t work for a shower pan, we tell you before the estimate is written, not after the tile is ordered.

Waterproofing and Substrate Work
Water damage behind tile doesn’t announce itself. It shows up as a loose tile, a stain on the ceiling below, or a musty smell that won’t leave. This is the stage most surface-level remodelers skip, and it’s the one that determines whether the shower lasts. We install Schluter waterproofing membranes and build a sloped, watertight shower base so moisture has one path out: the drain. It’s hidden work, and it’s the part we care about most.

Walk-In Shower Installation
A tub-to-shower conversion usually lands on a walk-in design, and that means a low or zero curb, framed or frameless glass, a bench or niche if the layout allows, and a showerhead height set for the people using it. We bring American Standard, Sterling and Toto into the conversation early so the valve and trim you choose matches the rough-in we’re building. If grab bars or a fold-down seat are part of the plan for aging in place, we block the walls for them during framing – retrofitting later is far more invasive.

Tile, Surrounds and Finish Work
What you see is the last 20% of the job, but it’s where a bathroom starts to feel like yours. We set large-format tile, build niches with properly sloped sills, and finish thresholds and transitions cleanly. Schluter profiles handle the edges where tile meets drywall or glass so there’s no raw cut or silicone bead masquerading as a finish. One scope, one crew, one finished space at the end.
Fixture and Drain Final Connections
Once tile cures, we set the valve trim, showerhead, drain grate and glass, then test everything. That means running water to check slope and drain speed, and checking the valve for leaks at both hot and cold. If something isn’t right, it gets caught before we pack up. This step also reveals whether your brand of choice fits the rough-in you have – Kohler and Moen use different valve bodies, and mixing them up means starting over.
Styles & brands we work with
- Walk-in shower
- Tub-to-shower
- Freestanding tub
- Kohler
- Moen
- Delta
- Frameless glass
Brands We Work With for Tub to Shower Conversion
We handle American Standard, Sterling, Kohler, Moen, Delta, Toto, Grohe and Schluter Systems, and we know where each one earns its price. American Standard and Sterling are the value end: reliable valve cartridges, straightforward trim, plenty of finish options for the money. Kohler and Moen sit in the reliable middle, and both hold up well in hard-water areas like ours. Toto and Grohe are the premium tier, with pressure-balance and thermostatic valves that give you real control over temperature. We don’t push a brand to match a quota; the recommendation follows the budget you set.
Schluter is the one we talk about most, because it’s mostly invisible when the job is done. Its waterproofing membranes, shower bases and tile profiles are professional-grade, and using them correctly means the substrate stays dry long after the grout lines have aged. When you buy Schluter, you’re buying a system, not a single piece – and it only works if it’s installed as one. Whether you have American Standard, Toto, Sterling, Kohler or any other make, we can help.
Signs a Tub to Shower Conversion Is Worth Doing Now
Some of these are comfort problems. Some are the kind that get more expensive the longer they’re ignored.

- You’re stepping over the tub wall and hesitating. That 14-inch lip is the number one reason homeowners call us about aging in place. A walk-in shower with a low curb or zero threshold removes the obstacle entirely, and if balance is a concern, we block for grab bars during framing.
- Water pools at the base of the tub or on the floor after a shower. Pooling points to a drain or slope issue, and the water has to go somewhere – usually into the subfloor. A conversion replaces that geometry with a properly sloped shower base.
- You find a soft spot, a bubbling grout line or a loose tile. Softness underfoot or at the surround means water has already reached the substrate. This is the sign that matters most: the damage is already happening, and it will not fix itself.
- The tub is scratched, chipped or stained in a way cleaning won’t touch. A worn enamel finish traps grime and looks worse every year. If you’re already planning new tile, the conversion cost is lower than re-facing a tub you don’t want.
- No one in the house takes baths. A tub you don’t use is square footage eating your bathroom. A walk-in shower opens the floor plan, makes the room feel bigger, and is what most buyers expect in a primary bath.
Our Tub to Shower Conversion Process in Paradise, Step by Step
- 1
Free estimate and measurement. We measure the alcove or footprint, photograph the existing valve and drain, and check the wall behind the surround. You get a written line-item quote covering demolition, rough-in, waterproofing, tile and fixtures. The price you sign is the price you pay.
- 2
Permit check and scheduling. Most municipalities require a permit for plumbing changes and rough-in work, so we check with the local building department before work starts. If a permit is required, we pull it and get the inspection handled. You get a start date and a realistic sequence.
- 3
Demolition and rough-in. We pull the tub, haul it out, and expose the framing and plumbing. The valve gets replaced, the drain gets repositioned if necessary, and any rotted framing is repaired and documented with photos. Nothing gets covered up before you’ve had a chance to see it.
- 4
Waterproofing and tile. Schluter membrane goes on the walls and the shower base is set with a proper slope. Then we tile, build the niche and set the door surrounds. Each layer cures before the next goes on, which is why the tile stays tight for years instead of months.
- 5
Final connections and walkthrough. Glass, drain grate, trim and showerhead go on, then we run the water and test. You get a walkthrough of the finished shower plus a rundown of what to check in the first month. The scope ends when you’re satisfied the work is complete.
See the difference
Before
After
Before
After
Before
AfterHow Much Does a Tub to Shower Conversion Cost in Paradise?
A typical tub to shower conversion in Paradise runs $3,500 to $10,000, depending on the size of the alcove, whether the valve and drain have to be moved, and the level of tile and fixture you choose. A smaller alcove with a simple surround and a value-tier American Standard valve tends to land near the bottom of that range. A larger footprint with a bench, a framed glass panel and Toto or Grohe trim climbs toward the top. If we uncover rotted framing or a failing shower pan behind the surround, the repair gets priced separately and approved in writing before anyone touches it.
What affects the price most: the glass style (frameless costs more than sliding), tile type and pattern, the extent of the rough-in work, and whether you need a permit. What keeps you from overpaying is a scope comparison, not a low number. A quote that skips waterproofing or skips the permit will look cheaper – and cost more later. Ask what’s behind the tile, and whether the waterproofing membrane is included. Our written estimate is free, itemizes every line, and locks the price for the project. No change orders unless you ask for the change.
Tub to Shower Conversion Near Paradise and Across the Valley
We serve homeowners across Paradise and the surrounding communities, including Winchester and Whitney and further out to Spring Valley, Enterprise, Henderson, Sunrise Manor, Summerlin, Las Vegas and North Las Vegas. Travel to the edges of the valley is routine. Whether you’re in an older ranch home or a newer build with a cramped tub alcove, we’re close enough to make the estimate easy to schedule. If you’re weighing a full remodel instead, our bathroom remodeling service covers the whole bath, and our Paradise page has more on our local work.
Serving Paradise, NV – Our Local Coverage Area
We serve Paradise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Tub to Shower Conversion in Paradise
A tub to shower conversion is a defined remodel where an existing bathtub is removed and replaced with a walk-in shower. It involves new plumbing rough-in, a waterproofed shower base, new tile or surround, and new glass and fixtures, all within the existing footprint. It’s different from simply installing a shower liner over an old tub: the drywall, old surround and tub itself come out. The result is a real walk-in shower sized to your alcove, not a compromise bolted on top of one.
Most conversions take about one to three weeks from demolition to finished shower, depending on the scope. Simple conversions with prefab panels and stock glass can move faster; custom tile, niches, frameless glass and moved plumbing add time. The area of waterproofing is what takes the longest, because each layer must cure before the next is applied. You get a realistic schedule in the written estimate so you can plan around it.
Typical estimates in Paradise run $3,500 to $10,000, with the final number set by your written estimate. Alcove size, glass style, tile selection, and whether the valve and drain need repositioning are the biggest variables. If hidden damage is found under the old tub, the repair gets priced and approved before it’s done. Call (888) 349-5908 for an exact quote – estimates are free.
Yes. We work with American Standard, Toto, Kohler, Moen, Delta, Sterling, Grohe and Schluter, and we know where each one’s valves wear or seize over time. That means the fixture you pick from the catalog will actually fit the rough-in we build, and you won’t hit a mismatch at final set. Call (888) 349-5908 to schedule your free estimate and we’ll talk through which valve makes sense for your water and your budget.
We answer 24/7, and we offer fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. For planned conversion work, the estimate and scheduling step happens first, then we set a start date. If a shower has failed and the job is urgent, tell us on the call and we’ll tell you what’s possible. Call (888) 349-5908.
Our warranty covers the workmanship on the installation, and manufacturer warranties cover the fixtures and valves we set, with the length depending on the brand and product line. The written estimate includes the warranty terms before you sign, so there’s no fine print left to find later. Waterproofing done to Schluter standards is covered as part of the installation. Call (888) 349-5908 for details on a specific scope.
Clear the bathroom of towels, toiletries and anything on the walls, and plan for the bathroom to be out of use during the work. If it’s the only shower in the home, arrange an alternative before demolition starts. Parking access and a clear path to the door make the tub removal easier. We’ll confirm the details when we schedule, and you can ask anything that isn’t covered.
Schedule Your Tub to Shower Conversion in Paradise Today
Your bathroom can be built around how you actually live in it, and a tub you never use is the first thing to go. Call (888) 349-5908 to schedule your free, no-obligation estimate for a tub to shower conversion in Paradise. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Written line-item quotes, waterproofed to Schluter standards, bathroom-only work. You’ll see the scope and the price before anything starts. Our Winchester and Whitney neighbors are welcome too.
Written by the team at Bathroom Remodeling Paradise.